Specification of DMX512 16pixel RGB pixel led bar

Description

this is dmx512 led bar , it’s made by black/white aluminum extrusion plus milky white /clear cover

the board designed by 48 pcs epistar 5050  RGB LED and 24V DC operation,this makes the installation much

easier and no need put lots of power cable
Each tube included 2pcs Aluminum clips (without screw) it’s cannot adjust the angle but it’s move-able horizontal
Each tube attached a pair of wateproof 3Pin connector output from bottom side ,this could achive No-slot joint

when two pcs tube link in series
Although it’s DC24V working , the addressable linear still requested to feed power every 10 meters

Product features

1. Working with DMX512 protocol directly, stable working performance and changing smoothly.

Standard DMX512 control protocol(Max 44frames/second).
2. Built-in regulator circuit, can better to protect the IC and extend the using time.
3. Wonderful performance operated by Madrix software.

4. Environment friendly, no harsh glare and buzzing noise, no flicker.
5. Parallel DMX signal, avoiding all lights influenced by the failure of one light in serial connection.
6. Waterproof, energy-saving, low-cost of maintenance, and long life span.
7. It is very cool for outdoor lighting, ferris wheel, nighclub, KTV,Disco decoration.

8.Electrical Protections: short circuit, over current, over voltage and over temperature.